3-16
3. Disassembly and Reassembly
Part
Photo
Description
Water Valve
The water valve is electrical controlled and solenoid operated. The
fl
ow of water is controlled by a
rubber
fl
ow washer capable of maintaining a
fl
ow of 4(±5%) liters per minute with incoming water
pressure of 0.04~1Mpa.The water valve is mounted to the front of base.
Preparation:
* Disassemble the bracket front lower & frame left.
- Refer the “bracket front lower” disassembly section.
1. Remove the two (2) screws and ground wire screw
from the inlet valve.
2. Lift up the inlet valve and disconnect the inlet valve
wire connector.
3. Release the hose clamp and disconnect hose.
Caution
Take care when holding and removing the clamp
with a tool, as it may bounce and harm you.
Caution
Make sure to remove remain water in the
dishwasher. If not, wet the
fl
oor.
Thermistor
Preparation:
* Disassemble the shutter.
- Refer the “shutter” disassembly section.
1. Disconnect the wire terminal connected to the
thermistor.
2. Release the two(2) screws of thermistor.
3. Pull out it carefully.
The thermistor has a seal .
坍
Reassembly is in the reverse order of the removal.
