setting up
_15
01 SETTING
UP
Connect the water line to the refrigerator.
-
Remove the compressor cover of the
refrigerator.
-
Connect the water line to the valve, as shown in
the fi gure.
-
When connected, check if there is any leakage.
If any, repeat the connection.
-
Reattach the compressor cover of the
refrigerator.
Secure the water line.
-
Using clip ”A”, fi x the
water line to the wall (the
back of refrigerator).
-
When the water line
is secure, make sure
whether the water line
is not excessively bent,
pinched or squashed.
Removing any residual matter inside the
water supply line after installing fi lter.
1. Turn ON the main water supply & turn OFF the
valve to the water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 1 L). This will clean the water
supply system and remove air from the lines.
3. Additional fl ushing may be required in some
households.
4. Open the refrigerator door and make sure there
are no water leaks coming from the water fi lter.
A newly installed water fi lter cartridge
may cause water to briefl y spurt from the
water dispenser. This is due to air getting
into the line. It should pose no problem to
operation.
WATER LINE
WATER LINE
INSTRUCTIONS COMPRESSOR
INSTRUCTIONS COMPRESSOR
COVER OF REFRIGERATOR
COVER OF REFRIGERATOR
CONNECTION NUT
CONNECTION NUT
CLIP A
CLIP A
WATER LINE
WATER LINE
DA99-02291S-02.indb 15
DA99-02291S-02.indb 15
2014. 7. 19.
9:00
2014. 7. 19.
9:00
