12_
setting up
CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system
to do that. In order for the icemaker to operate
properly, water pressure of 138~862 kPa is
required. Under normal conditions, a 170 cc paper
cup can be fi lled in 10 seconds. If the refrigerator
is installed in an area with low water pressure
(below 138 kPa), you can install a booster pump to
compensate for the low pressure. Make sure the
water storage tank inside the refrigerator is properly
fi lled. To do this, press the water dispenser lever
until the water runs from the water outlet.
Water Line installation Kits are included.
You can fi nd it in one of the freezer drawers.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
USING THE ICE MAKER
(OPTIONAL)
To Remove the Ice Bucket
-
Hold the handle as shown in
fi gure1.
-
Slightly pull up the bottom
part.
-
Take out the ice bucket slowly.
To Refi t The Ice Bucket
-
Assemble it in the reverse
order of disassembly.
-
Push the bucket in fi rmly until
you hear a clicking sound.
-
When the bucket does not fi t
into its place, turn the gear
handle on its back by 90
degrees and reinstall it again
as shown in fi gure 2.
Normal Operation
-
Any sounds you hear when
the ice maker dumps ice into
the bucket are part of normal
operation.
-
Not dispensing ice for long
periods may cause ice clumps
in the ice bucket. Remove the
remaining ice and empty the
bucket.
-
When ice does not come out, Check for any ice
stuck in the chute and remove it.
-
The fi rst batch of ice cubes may be small due
to air in the pipe after connection, any air will be
purged during normal use.
- When ICE OFF blinks on the display
panel, reinsert the bucket and/or make
sure it’s installed properly.
-
When the door is open, the Ice and water
dispenser do not work.
-
If you close the door hard, it may cause water
spilling over the ice maker.
-
To prevent dropping the ice bucket, use both
hands when removing it.
-
To prevent injury, be sure to clean up any ice or
water that may have dropped on the fl oor.
-
Do not let children hang on the ice dispenser or
on the bucket.
They may get hurt.
-
Be sure not to put your hand or any object into
the ice chute.
-
It may cause personal injury or damage
mechanical parts.
INSTALLING THE WATER
DISPENSER LINE
For Interior model
Parts for water line Installation
Connecting to the water supply line
1. fi rst, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
3. follow the Water line Installation Instructions in
the installation kit.
CAUTION
Figure2
Figure2
Ice Chute
Ice Chute
Figure1
Figure1
CAUTION
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifi er to malfunction.
1
Water line fi xer and screws
Water line fi xer and screws
2
Pipe connector
Pipe connector
3
Water line
Water line
4
Clip
Clip
5
Water Filter
Water Filter
DA99-02291S-02.indb 12
DA99-02291S-02.indb 12
2014. 7. 19.
9:00
2014. 7. 19.
9:00
