Samsung AM071NN1DEH/TL, Instruction Manual

Page: 28 / 40

28
Installation Procedure
English
Installation Pr
oc
edur
e
Installation options for the 02 series
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2
Use of auto
cleaning function
Use of external
temperature
sensor /
Minimizing fan
operation when
thermostat is off
Use of central
control
Compensation of
the fan RPM
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Use of drain pump
Use of hot water
heater
-
EEV step when
heating stops
Dew removal
operation in wind
free mode
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
Use of external
control
Output of external
control / Output of
external heater /
Output of cooling
operation / Output
of cooling through
external air intake
S-Plasma ion Buzzer control
Maximum filter
usage time
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Individual control
with remote
control
Heating setting
compensation
offset / Removing
condensated
water in the Heat
mode
EEV step of
stopped unit
during the oil
return or the
defrost mode
Motion detection
sensor
Cycle time of
Swing
࡛
Even if you set the Use of drain pump (SEG8) option to 0, it is automatically set to 2 (the drain pump is used with 3
minute delay).
࡛
If you set the Maximum filter usage time (SEG18) option to a value other than 2 and 6, it is automatically set to 2
(1000 hours).
࡛
If you set an option to a value that is out of range specified above, the option is automatically set to 0 by default.
࡛
The SEG5 option (Use of central control) is set to 1 (Use) by default. Therefore, you don't need to set the SEG5 option
additionally. Note that even if the central control system is not connected, no errors occur. If you want a specific
indoor unit not to be controlled by the central control system, set the SEG option of that indoor unit to 0 (Disuse).
࡛
The external output of SEG15 is generated via MIM-B14 connection. (Refer to the manual of MIM-B14.)
࡛
If you set the Individual control with remote control (SEG20) option to a value other than 0 to 4, it is automatically set
to 0 (Indoor 1).
࡛
The output of hot water heater in SEG9 is generated from the hot coil part of the terminal board in duct models.
Outdoor
Communication
(+) (-) COM2
DC 12 V Wire Remote
Controller
AC
POWER
HOT
COIL
L N COM1
७Ɵ˵ʪͱЇϩΧЇϩͱ˙˵ͱϩʀͱ̷̈ϩʪθ͔̈͝ɇ̷̈ϑAߤߤߢǤࢩߤߥߢǤ
(The same as Indoor Unit’s input Power)