Internet in the Client
screen.
If not, that indicates that the LAN connection is disconnected. In this
case, connect using another LAN cable.
2) Check if the settings of the 'Network' tab of 'Settings' have been
properly set up. The default setting is "DHCP". If your network uses a
static IP address, select 'Use the following IP address' and then enter the
appropriate IP address information.
The contents (video,
voice) on the server do
not play smoothly on
the Client Monitor.
This is because the data is transmitted over the LAN. Check your LAN
connection status.
I have connected a
digital device such as a
digital camera,
camcorder or USB
memory to the USB
port, but they do not
work.
This model supports USB devices that support removable disk functions
without an additional driver installation. Check if the device you want to
connect to is a device that supports the removable disk function without
an additional driver installation.
The file list does not
appear.
1) Check the files on the card. If only abnormal files (e.g. 0KByte, broken
JPEG) exist, the files do not appear on the screen.
2) The time required to display is determined by the size of the file. Wait
a moment.
3) Check if the format of the file is supported by the Client Monitor. If the
extension of the file has been changed, the file will not be played.
Check the following items if there is trouble with the monitor.
1. Check if the power cord and the video cables are properly connected to the computer.
2. Check if the computer beeps more than 3 times when booting.
(If it does, request an a service for the main board of the computer.)
3. If you installed a new video card or if you assembled the PC, check if the installed the adapter
(video) driver and the monitor driver.
4. Check if the scanning ratio of the video screen is set to between 56 Hz ~ 75 Hz.
(Do not exceed 75 Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "
Control Panel
→
System
→
Device Administrator
" and then
reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur,
contact an authorized service center
.
Q & A
Question
Answer
How can I change the
frequency?
The frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version
of the driver used. (Refer to the computer or the video card
manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution in the Control Panel
→
Display
→
Settings.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function?
Windows ME/XP/2000 : Set the function at BIOS-SETUP of the
computer or the screen saver. (Refer to Windows/Computer
Manual).
