Samson Type 5824, Mounting And Operating Instructions

Page: 23 / 64

EB 5824-1 EN 5-1
Installation
5 Installation
5.1 Installation conditions
Work position
If not described otherwise in the valve docu-
mentation, the work position for the control
valve is the front view looking onto the oper-
ating controls.
Mounting orientation
The control valve can be installed in the
pipeline in any desired position. However, a
suspended mounting position of the actuator
is not permissible (see Fig. 5-1).
0...90°
0...90°
6
!
6
6
6
Fig. 5-1: Mounting position
Risk of actuator damage due to adverse
weather conditions.
Î
Do not use the actuator outdoors.
The degree of protection IP 54 can only be
achieved up to device index .03 when the
actuator is installed in the upright position.
See the last two figures of the configuration
ID written on the nameplate for the device
index.
5.2 Preparation for installation
Before mounting, make sure the following
conditions are met:
− The actuator is not damaged.
Proceed as follows:
Lay out the necessary material and tools to
have them ready during mounting.
Cover screws
The front housing cover of the electric actua-
tor is fastened using TORX PLUS
®
screws,
size 10IP.
Î
To loosen and tighten the screws, the
following screwdrivers can be used:
− TORX
®
T10
− TORX PLUS ® 10IP
− Flat-blade screwdriver with 0.8 mm
blade thickness and 4.0 mm blade width
NOTICE !
Note