Samson 5007-2 Series, Mounting And Operating Instructions

Page: 28 / 72

5-2 EB 9510 EN
Installation
3. If applicable, insert an option module
(see section 5.3.2).
4. If applicable, set up the standby power
supply (see section 5.3.2).
5. Place on the cover and make sure that
the inserted option modules are seated in
the openings intended for them in the
cover.
6. Fasten the cover.
b) Setting up when the gateway
has already been put into
service
Risk of fatal injury due to electric shock
(230 V version).
Î
Before connecting wiring, performing
any work on the device or opening the
device, disconnect the voltage supply
and protect it against unintentional re
-
connection.
Î
Only use power interruption devices that
are protected against unintentional re
-
connection of the power supply.
Risk of damage to components for optional
additional functions due to electrostatic dis-
charge.
Î
Observe the ESD requirements according
to IEC 61340-5-1.
1. Disconnect the electrical power supply
from the gateway and connected mod-
ules.
2. Undo the five screws on the cover and
remove the cover.
3. If applicable, insert an option module
(see section 5.3.2).
4. If applicable, set up the standby power
supply (see section 5.3.2).
5. Place on the cover and make sure that
the inserted option modules are seated in
the openings intended for them in the
cover.
6. Fasten the cover.
5.3.1 Inserting option modules
When replacing an option module, remove
the inserted option module as described in
the 'Removal' section.
Four slots to hold option modules exist in the
gateway (see Fig. 5-1).
1. Open the cover and insert the option
module into one of the slots, making sure
it is inserted correctly.
2. If necessary, break open the openings
for the terminals in the cover (by pressing
the predetermined breaking points).
DANGER !
NOTICE !
Note