Samson 3738-20, Mounting And Operating Instructions

Page: 82 / 84

Parameter list
P0 Info: actual value
P1 Reading direction
P2 Configuration: RUN/SET
P3 Verify LCD segments (TSTD)
P4* Actuator type
P5* Actuator's direction of action
P6* Switching function of contacts A, B, C
P7* Switching contact, lower end position
P8* Switching contact, upper end position
P9* Automatic initialization (INIA)
P10* Manual initialization (INIM)
P11* End position calibration (REF)
P12* Issue status PST target range
P13* Status indication actuator transit time
P14* PST step end
P15* PST tolerance band
P16* Start automatic PST
P17* Start manual PST (PST)
P18* Lock operation
P19* Testing contacts A, B, B_LB, C, St (TSTC)
P20* Testing solenoid valve (TSTS)
P21* Reset (RST)
P22 Info: actuator transit time when solenoid valve is
de-energized
P23 Info: actuator transit time when solenoid valve is
energized
P24 Info: temperature
P25 Info: operating hours
P26* Max. rotary motions
P27* Reset rotary motion counter
P28 Info: firmware version
Status messages
F0 Stationary outside required/desired end posi-
tions
F1 Left end position without being required to move
F2 Limit of P26 exceeded
F3 Temperature limits exceeded
F4 Actuator transit time exceeded
F5 Actuator stationary when required to move
F6 Min. value for PST not reached
F7 Max. value for PST exceeded
F8 No switching voltage during PST
F9 Time-out during PST
F10 Error E0 to E10 exists
F15 Configuration mode SET activated
Error messages
E0 No initialization
E1 INIT: actuator does not move
E2 INIT: min. travel not reached
E3 INIT: max. travel exceeded
E4 INIT: actuator travels too fast
E5 INIT: no switching voltage applied
E6 INIT: time-out
E7 Function canceled
E8 Unable to calibrate end positions
E9 Device error 1
E10 Device error 2
The parameters/errors marked with an asterisk (*) can
only be changed/confirmed in the SET configuration
mode.