H11
www.samon.nl - [email protected]
V1-2023-EN
5.5
Automatic depth control
If the SAMON Haulm Topper is equipped with an automatic depth control, it will be necessary to adjust the
cutting height and working width of the probes.
➔
Cutting height
adjustment:
5.5.1
➔
Width adjustment:
5.5.2
5.5.1 Adjusting automatic depth control folding height
•
Set the lifting device of the tractor with the SAMON Haulm Topper in "floating mode"
•
Make sure automatic depth control is turned on.
•
Loosen the locking bolts of the height adjustment.
•
Remove the locking brackets from the pivot levers.
•
Check that the reaction plate is located between the two sensors.
•
Turn the levers to set the desired cutting height.
•
Lock the pivot levers with the catches.
•
Tighten the locking bolts of the height adjustment.
5.5.2 Adjusting width of automatic depth control probes
To ensure maximum performance of the automatic depth control, the probes must run in the appropriate
tracks.
•
Loosen the locking bolts from the width adjuster of the probe legs.
•
Move the legs until the depth control probes fall in the appropriate track.
•
Secure the probe legs with the locking bolts.