H9
www.samon.nl - [email protected]
V1-2023-EN
5.3
Gear drive maintenance
The gear drives are filled in the factory with gear drive oil (SAE 90).
NOTE!!!
The gear drive oil must be replaced every 2 years.
5.3.1 Topping up the gear drive oil
•
Make sure the SAMON Onion Haulm Topper is standing on a flat, level surface.
•
Remove the PTO shaft(s).
•
Remove bleed nipple or vent hose (A) at the top.
•
Remove plug (C) from the gear drive.
•
Fill the gear drive with oil (SAE 90) until oil starts coming out of plug hole (C).
•
Fit plug (C) and bleed nipple (A)
•
Mount the PTO shaft.
5.4.2 Replacing the gear drive oil
•
Remove the PTO shaft.
•
Remove the drive belts.
•
Remove the gear drive from the frame.
•
Remove bleed nipple (A) at the top.
•
Remove plug (B) from the bottom of the gear drive.
•
Drain the gear drive and collect the oil in a container - make sure to dispose of it in an ecologically
responsible manner.
•
Tighten plug (B) and place the gear drive back in the frame.
•
Remove plug (C) from the gear drive.
•
Fill the gear drive with oil (SAE 90) until oil starts coming out of plug hole (C).
•
Fit plug (C) and bleed nipple (A)
•
Install and adjust the drive belts.
•
Mount the PTO shaft.
