www.larius.com
8
THOR
ED.
17 - 09/2020 - Cod. 150096
ALARM MESSAGE TABLE
TRANSPORT AND UNPACKING
• The packed parts should be handled as indicated in the
symbols and markings on the outside of the packing
.
•
Before installing the equipment, ensure that the area to
be used is large enough for such purposes, is properly
lit and has a clean, smooth floor surface
.
• Check the packing is undamaged on receipt of the
equipment. Unpack the machine and verify if there has
been any damage due to transportation.
In case of damage, call immediately
LARIUS
and the
Shipping Agent.
All the notices about possible damage or anomalies must
arrive timely within 8 days at least from the date of receipt
of the plant through Registered Letter to the Shipping
Agent and to
LARIUS
.
• The manufacturer will not be responsible for the unloading
operations and transport to the workplace of the machine
.
Alarm symbol
Type of alarm
CAuse
Solution
F1
Maximum current
The motor’s current absorption
is too high
Check the mechanical and hydraulic
condition of the equipment. If
necessary, take action
F2
Dissipator temp.
The dissipator temperature is
too high
Check that the dissipator surfaces
are clean and that the dissipator is
properly ventilated
F3
Motor temp.
The motor temperature is too
high
Check that the motor’s heat dissipation
surfaces are clean. Check that cooling
ventilation is correct
F4
Maximum voltage
The voltage is too high
Check the connection to the electrical
line and reinstate the correct nominal
voltage
F5
Minimum voltage
The voltage is too low
Check the connection to the electrical
line and reinstate the correct nominal
voltage
F6
Earth connection
The earth connection is
disconnected or non-existent
Check the earth cable and, if necessary,
replace it. Make sure that the machine
is earthed
F7
Pressure sensor missing
The pressure sensor is
damaged or not fitted
Replace it
F8
Automatic switch-off
during circulation phase
(15 minutes)
The equipment is in cleaning
mode
Wait until the equipment has stopped
completely before using it for a new job
The user is responsible for the operations of
unloading and handling and should use the
maximum care so as not to damage the individual
parts or injure anyone.
To perform the unloading operation, use only
qualified and trained personnel (truck and
crane operators, etc.) and also suitable hoisting
equipment for the weight of the installation or its
parts. Follow carefully all the safety rules.
The personnel must be equipped with the
necessary safety clothing.
The disposal of packaging materials is a custo-
mer’s competence and must be performed in
accordance with the regulations in force in the
country where the plant is installed and used.
It is nevertheless sound practice to recycle
packaging materials in an environment-friendly
manner as much as possible.
E
