Index revision : A
32
7143
Required material:
• Clean lint-free cloths.
• Cleaning agent PS 1098 (P/N: 100000037).
• Butyl rubber gloves(
• Safety glasses.
• Protective mask.
• Telescopic bridge (
).
Procedure for the maintenance of the interior of the booth
:
•
Carry out an interior cleaning of the booth using the cleaning rod provided for this pur-
).
• Wipe a very lightly moistened and clean cloth over the entire interior surface of the booth
to remove dust.
• Gradually clean the outer surface of the booth with a cloth soaked in cleaning agent in
circles of about one square meter, then wipe with a dry, clean cloth and so on over the
entire surface. Clean from top to bottom with emphasis on difficult spots.
• Switch on booth ventilation.
WARNING :
Drying time:
•
Leave to dry for 48 hours without powder projection.
5.2.2. Procedure
A2
: Booth exterior cleaning
Once a year, clean the exterior of the booth with PS 1098 (P/N: 100000037) recommended by
SAMES KREMLIN
.
Follow the procedures described below:
Required material
• Clean lint-free cloths
• Cleaning agent PS 1098 (P/N: 100000037)
• Stepladder with rubber feet to avoid marking the plastic floor.
• Butyl rubber gloves(
• Safety glasses
• Protective mask
• Elevating platform for roof access.
Procedure for the maintenance of the exterior of the booth
:
•
Wipe a very lightly moistened and clean cloth over the entire exterior surface of the booth
to remove dust.
• Gradually clean the outer surface of the booth with a cloth soaked in cleaning agent in
circles of about one square meter, then wipe with a dry, clean cloth and so on over the
entire surface. Clean from top to bottom with emphasis on difficult spots.
WARNING :
Drying time:
•
Leave to dry for 48 hours without powder projection.
WARNING : It is imperative to take care not to spray any cleaning product into the ventilation
duct (risk of powder deposition that can generate pollution when changing colors) and on the
projectors.
