SaMASZ KDF 260, Operator'S Manual, Page: 14 / 42

Operator’s manual
Front disc mowers
KDF
- 12 -
Fig. 6. Location of centre of gravity KDF mowers
Tab. 7. Location of centre of gravity
Dimension
[mm]
Model
KDF 260 KDF 300 KDF 340 KDF 390
KDF 260
S(SL)
KDF 300
S(SL)
KDF 340
S(SL)
A
730 750 880 605 880 890 903
B
620 590 680 790 620 560 590
C
1670 1890 2120 2340 1610 1830 2055
D
1440 1650 1830 2060 1490 1710 1895
Dimension
[mm]
Model
KDF 301
S(SL)
KDF 341
S(SL)
KDF 300 W KDF 301 W KDF 340 W
KDF 341
W
A
890 903 880 880 1015 1015
B
560 590 590 590 590 590
C
1830 2055 1780 1780 2085 2085
D
1710 1895 1750 1750 1860 1860
4.4. Working parts
Before operating the mower check knife’s and knife holder’s condition.
Worn or damaged knives or knife holders should be immediately replaced with new one.
4.5. PTO shaft
Before operating learn provisions found in bar manufacturer's manual placed on the bar.
Use only PTO shafts recommended by mower’s manufacturer.
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO
shaft shall be repaired or replaced with new one.
4.6. Hydraulic assembly
Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate
through skin and cause serious injury, therefore skin and eyes should be protected in particular.
In case of injuries caused by a liquid under pressure, call a doctor immediately.
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the tractor’s and
the mower's hydraulic assemblies are not under pressure. To remove the pressure from the
hoses just simply restart the tractor's hydraulic valves several times, once the tractor is off.
B
A
C D