Sam4s ER-180T, Operator'S And Programming Manual

Page: 55 / 89

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming

55
Department Programming
Program 500 - Department Status Programming
Use the following steps to set the status for each department.
1. Turn the key lock to the P position.
2. To begin the program, enter 5 0 0 and press the SUBTOTAL key.
0 SUBTOTAL 0 5
3. Select the Department or Departments you wish to program in one of the following
ways:
Press a Department key on the keyboard, or
1
To set a group of departments with the same status, press the first department in the
series and then press the last department.
16 1
4. Refer to the "Department Status Chart" below to determine the values for N1 through
N8. Enter the values you have selected, press the
X/TIME key. (You do not need to
enter preceding zeros.)
N3 N2 N1 N4 N5
X/TIME
(X)
N6 N7 N8
5. To program additional Departments, repeat from step 3, or press the CASH/TEND
key to finalize the program.
CASH/TEND
(=)
Department Status Chart
Address Program Option Value
N1
Department is negative item Yes = 1
No = 0
N2
Department is single item Yes = 1
No = 0
N3
Department is taxable by rate 4? Yes = 1
No = 0
N4
Department is taxable by rate 3? Yes = 1
No = 0
N5
Department is taxable by rate 2? Yes = 1
No = 0
N6
Department is taxable by rate 1? Yes = 1
No = 0
N7
Department is override preset ?
Yes = 1
No = 0
N8
Department is preset? Yes = 1
No = 0
Note: Default settings are shown in bold type.