Salva ST-02, Installation And Operating Instructions Manual

Page: 24 / 73

SALVA INDUSTRIAL, S.A
File: Horno Modular 02 (ing) 180711
4-4
4.2 OPERATION OF CONTROL PANEL
4.2.1 Automatic regulation of deck temperature.
Once you have connected the general switch on the control panel using key 10 (L4 Led on), the
temperature in the module chamber can be controlled using keys 1 (the temperature will flash on
and off) 5 and 6. You can select the temperature you require for the cooking process to be carried out
(within the established range) and the oven will automatically ensure that it remains constant. This
temperature is displayed on the LCD screen in the temperature control zone. To return to the normal
screen, press key 1 once again or simply wait ten seconds.
Using keys 2 (which displays the different power settings in flashing mode), 5 and 6, you can
adjust the temperature setting for the top, bottom or front elements independently, choosing the most
suitable setting in each case. This enables you to establish a series of temperature combinations with
which to ensure ideal cooking conditions for each product. When the top, bottom and front elements are
activated, the corresponding segments will light up. This is displayed on the LCD screen, in the power
setting zone. In order to return to the normal screen, press key 2 once again or simply wait 10
seconds. Temperature measurement.
The temperature control zone on the LCD screen indicates the temperature inside the cooking
chamber at all times, in either degrees centigrade or degrees Fahrenheit.
When the temperature symbol is displayed, this indicates that the temperature of the chamber is lower
than the programmed temperature.
4.2.2 Compensating loss of temperature inside the chambers due to opening
of door
Inside the chamber. two heating units are located both on the roof and on the floor of the mouth, and
these have been designed to compensate temperature losses which are due to opening of door of the
deck in order to load and unload the product. Temperature regulation in these heating units is carried
out by pushbutton 2, 5 and 6.
The power setting zone of the LCD screen indicates whether the respective heater units are on or
off, and displays the setting assigned to each unit.