8
GENERAL FUNCTIONS
Switching the Ultra Bass System on and off
This function boosts the bass frequencies. You can follow the below procedure to switch on and off the
UBS when the sound setting is CLASSIC, POP, JAZZ or ROCK.
1. Press and hold the
DSC/UBS button
to switch the Ultra Bass System on and off.
Notes:
Listening with UBS at high volume may have distortion. Recommend to use at low volume.
Listening with headphones
1. Connect the headphones to the
Headphone socket
(Ø3.5mm).
– This switches off the loudspeakers.
Warning:
Excessive sound pressure from earphones and headphones can cause hearing loss.
TIME SETTING
In standby mode, when the time and day flash on the display, this indicates that they need to be set.
Time setting may only be performed in standby mode.
1. Press the
Time button
to select the hour format between 12HR and 24HR.
2. Press and hold down the
Time button
until the hour digits flash on the display.
3. Set the hour by using the
Rewind
or
Forward button
, and press the
Time button
to confirm.
The minute digits flash.
4. Use the
Rewind
or
Forward button
to set the minute, and then press the
Time button
to confirm.
The day of week flashes.
5. Set the day of week by using the
Rewind
or
Forward button
, and press the
Time button
to
confirm.
“CT ON” flashes on the display.
6. Use the
Rewind
or
Forward button
to set the RDS time synchronisation, press the
Time button
to
confirm and finish the time setting.
Notes:
You must reset the time after a power failure or when the mains plug is pulled out.
Some RDS stations transmit an RDS time signal. If the selected RDS programme transmits this time
information, the time will be automatically updated. This may take a few minutes.
elite2_ib.indd 9
1/3/2011 17:48:06
