Salamander Designs - Electric Lift & Tilt, Mobile Display Stands www.salamandercommercial.com
501-631 [04.20] page 4 of 23
Duty Cycle of the motor control system:
The duty cycle is 10% ~ 6 min./ hour or max. 2 min. of continuous use, irrespective of the load.
This must NOT be exceeded as this will result in a superheating of the motor. Exceeding the duty
cycle will result in a dramatic reduction of the life of the system.
The standard motor control system range contains the following components:
• 1 control box
• 3 Telescoping actuators
• 1 exchangeable main power cable
• 3 motor cables
• 1 Wired remote control
Troubleshooting / Initialization of the motor control system
If motor control system malfunctions follow these steps;
The system is initialized by pressing the down button once or twice and holding it down until unit runs
into end stop, it will then automatically run approx. 3 mm out again and hereafter slowly running in
again. Only release the down button when the movement has completely stopped. If the key is released
before the sequence is completed then the initialization is interrupted and must be started again from
the beginning. It is sometimes necessary to press the down button twice to start the initialization
this is because the system can be in different modes when the initialization starts.
WARNING: Risk of Electric Shock – Connect the device to a properly grounded outlet only. Do not
defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong is provided for your safety. If the provided plug does not fit into
your outlet, consult an electrician for replacement of the obsolete outlet. Do not use a plug adapter
that defeats the ground pin of the AC plug.
WARNING: Do not overload the wall outlet where this device is being connected. Do not overload this
device. Ensure the total load to this device does not exceed that which is listed in the specifications
section of this manual.
Maintenance
• DANGER – To reduce the risk of electrical shock: Always unplug this device from
the electrical outlet before cleaning.
• Clean dust and dirt with a dry cloth, on the outside of the system at appropriate
intervals and inspect for damage.
• Inspect the connections, cables, and plugs and check for correct functioning
as well as video monitor fixing points.
Repairs
• Refer all servicing to qualified service personnel. Servicing is required when the device
has been damaged in any way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the device, the device has been exposed
to rain or moisture, does not operate normally, or has been dropped.
• There are no user-serviceable components within this device. Removal of
the cover from this device may present a shock hazard, and void the warranty.
Accessories and Spare Parts
Please contact your nearest Salamander Designs dealer or www.salamandercommercial.com
