Page 15
Turning an Alert ON or OFF SET-2 (Figure 3G)
Figure 3G
1.
Press the
SET
key in the completion alarm setting
mode. The alert On/Off setting mode display “SET-2”
in the Speed display.
NOTE:
Allows the operator to turn On/Off a End of
Process alarm to prevent slides from drying.
2.
Use the
UP
(
) and
DOWN
(
) arrow keys once at
the end of a run to select “Off” to sound the completion
buzzer. Or select a desired time interval in one-second
increments (selectable from 0 second to 60 seconds) to
keep the completion buzzer sounding. The value is
displayed in the Time display, like “On00” or “On60”,
and circulated on every key press.
3.
Press the
SET
key to save the change and enter
the sound volume setting mode.
Selecting a Sound Volume SET-3 (Figure 3H)
Figure 3H
1.
Press the
SET
key in the alert On/Off setting mode.
The sound volume setting mode displays “SET-3” in the
Speed display.
NOTE:
Three sound volume levels are available for the
completion and error alarms. Use the
UP
(
) and
DOWN
(
) arrow keys to change the value in the Time display from
1 - 3. Each setting is as follows:
1: (Low)
2: (Middle)
3: (Loud)
2.
To test the sound volume, press the
START/STOP
key.
Press the key again to stop the alarm.
3.
Press the
SET
key to save the change and switch to the
software version number display.
Viewing the Software Version Number (Figure
3I)
Figure 3I
1.
Press the
SET
key in the sound volume setting mode.
The version number of the software currently installed
in the instrument is displayed.
2.
Press the
SET
key to switch to the error code display.
Viewing Error Codes (Figure 3J)
Figure 3J
Error Codes have been programmed into the Cyto-Tek 2500
Cytocentrifuge. These 2-digit codes alert the operator to a
possible instrument malfunction or operating error. They
are displayed in the Speed Display window. An alarm
buzzer sounds when an error code is displayed.
1.
Press the
SET
key when the software version number
is displayed. The error code display appears.
2.
The last three errors codes are listed.
