– 30 –
2.2.2 Seat adjustment (option)
Adjust the seat for your best operating position.Move the
lever as shown by arrow. With the lever held in that position,
slide the seat forward or backward as desired. When properly
adjusted, releasse the lever.
Adjust your seat position to suit you as follows:
1) Pull the lever
①
and adjust seat position longitudinally.
2) Turn the backrest adjust pull the lever
②
for optimum angle.
3) Move the suspension lever
③
to select suitable
suspension for your body weight.
IMPORTANT
Be sure to wear the seatbelt during operation.
2.2.3 Adjustment and replacement of scraper
The method of adjustment and replacement of scraper is
the same both for front and rear drums.
1) Adjustment of clearance between scraper blade
Ⓐ
and
roll
①
Loosen set bolts
Ⓑ
(two locations).
②
Loosen bolts
Ⓒ
(six locations). Slide blade
Ⓐ
until it
touches the roll.
③
When the blade touches the roll, tighten bolt
Ⓒ
.
④
Adjust the clearance between the roll and blade
using set bolt
Ⓑ
.
2) Replacement of scraper blade
①
Remove bolts
Ⓒ
(six locations).
②
Replace blade
Ⓐ
with a new one.
③
Attach bolts
Ⓒ
(six locations) and tighten them.
NOTE: •
The scraper can be raised so that it will not be in contact with the roll during
operation.
•
The force to press the scraper blade to the roll can be adjusted by bolts
Ⓓ
(two
locations) and nuts
Ⓔ
(four locations).
WARNING
• Hold blade
Ⓐ
and raise it slowly so that your hand will not be caught between the
roll and blade.
• When returning raised blade
Ⓐ
to the original position, exercise care so that your
hand will not be caught between the roll and blad
(Lower side)
A
B
C
D
E
(Upper side)
A
C
D
E
B
①
①
③
②
②
