Sakai SV410-2, Shop Manual

Page: 48 / 270

3-006
ENGINE AND CONTROLS
3-2. Installation of Pump
When the pump has been removed from the engine for
repair or replacement, reinstall it in accordance with the
following procedure.
①
Apply adequate amount of grease to pump (1) and hub (3)
splines.
②
Install snap ring (4) of hub (3) to pump (1) and set to the
specified dimension.
Specified dimension a: 9 mm (0.35 in.)
③
Secure hub (3) with bolts (9).
N•m
(9) Bolt M12×35 : 86 N·m (63 lbf·ft)
④
Secure flange (2) to engine flywheel with eight bolts (8).
N•m
(8) Bolt M10×35 : 49 N·m (36 lbf·ft)
⑤
Secure housing (7) to engine flywheel housing with ten
bolts (10), two bolts (12) and washers.
N•m
(10) Bolt M10×25 : 59 N·m (44 lbf·ft)
(12) Bolt M10×30 : 59 N·m (44 lbf·ft)
⑥
Engage hub (3) with flange (2).
⑦
Secure pump (1) to housing (7) with four bolts (11), spring
washers and washers.
N•m
(11) Bolt M14×45 : 167 N·m (123 lbf·ft)
(NOTICE)
Bolt (8) is treated with thread-locking fluid. Use new
thread-locking fluid treated bolt for installation.
•
★
•
SV400-2-03007
B
B
8
3
4
2
A
A
SECTION A-A
7
10
11
12
1
9
SECTION B-B
a