Sakai SV410-2, Shop Manual

Page: 260 / 270

9-055
TROUBLESHOOTING
3-2-1. Machine moves neither forward nor backward 2/2
Check point Cause Check/Action
9. Propulsion Pump Discharge flow rate is insufficient due to
efficiency degradation of propulsion pump.
Measure discharge flow rate of propulsion
pump with flow meter.
If discharge flow rate is not within specified
range, repair propulsion pump or replace it
if necessary.
•
•
Discharge flow rate is insufficient due to
wear of propulsion pump drive shaft splines.
Replace propulsion pump.
Propulsion circuit pressure is not held in
propulsion pump case.
If pressure in propulsion pump case is not
within allowable range, repair propulsion
pump or replace it if necessary.
10. Parking Brake
Solenoid Valve
Brake remains applied because spool of
parking brake solenoid valve does not shift.
Repair parking brake solenoid valve or
replace it if necessary.
11. Brake Inlet
Pressure
Brake cannot be released because brake
inlet pressure is low.
Measure brake release pressure.
If low, repair or replace propulsion motor.
•
•
12. Rear Axle Sticking of disc brakes causes brakes to
remain applied.
Replace disc brakes. •
13. Flange Drive torque is not transmitted to pump due
to faulty flange.
Replace flange.
3-2-2. Machine moves in one direction only (forward or backward)
Check point Cause Check/Action
1. F-R Lever Linkage F-R lever linkage is faulty. Check and adjust F-R lever linkage or
replace it if necessary.
2. Multifunction Valve Low circuit pressure due to incorrect high
pressure relief setting or internal leakage of
multifunction valve.
Interchange two multifunction valves.
If faulty condition is accordingly reversed,
check and adjust multifunction valve or
replace it if necessary.
•
•
3-2-3. Slow machine speed or small drive force 1/2
Check point Cause Check/Action
1. Bypass Valve Bypass valve is slightly open. Close bypass valve completely.
2. F-R Lever Linkage F-R lever linkage is faulty. Check and adjust F-R lever linkage or
replace it if necessary.
3. Charge Circuit
Pressure
Stroke of propulsion pump swash plate
is small because charge pressure is low,
decreasing discharge rate of propulsion
pump.
Measure charge pressure.
If low, check and adjust charge relief valve
or replace it if necessary.
•
•
Insufficient steering • charge pump
discharge.
Repair steering • charge pump or replace it
if necessary.
Charge pressure decreases due to internal
leakage of solenoid valve connecting oil
supply circuit with charge circuit.
Parking brake solenoid valve
Rear motor solenoid valve
•
•
When solenoid is energized, check if oil
flows in return circuit to tank.
If oil is flowing, repair solenoid valve or
replace it if necessary.
•
•
4. Suction Filter for
Steering • Charge
Pump
Flow rate of steering • charge pump
decreases as well as charge pressure
decreases due to clogged filter.
Clean suction filter or replace it if necessary.