- 60 -
LED lamps state
Description
A
Green/R
ed LED
lamp
Green lamp flicker
from bottom to top
Battery discharging
Green lamp flicker
from top to bottom
Battery charging
Red lamp flicker:1
s/time
Standby
Green lamp and red
lamp flicker in
alternative
Procedures are being upgrade
Red lamp Always light
on
Faults in device
B
Residual battery capacity
percentage (SOC)
Total remained battery capacity of the system
Table 5.1 Human-computer interface description
5.2 Start Up the Inverter
If only AS1 is installed, the system shall be turned ON in the correct
sequence as follows:
1) Turn ON the DC switch at the right side of the AS1;
2) Turn on the battery switch at the right side of the AS1 until it lights
in blue.
3) Wait for 30s and observe the LED indicators and LCD on the front
of AS1 to check the running status of the system. (Please refer to
Table 5.1)
If there is any B1 connected to the AS1, the system shall be
turned ON in the correct sequence as follows:
Summary of Contents for AS1-3KS-5.1
