Saipa tiba, Owner'S Manual

Page: 112 / 193

112
Emergency Starting
Booster cables connections
Connect the booster cables in
order of the numbers indicated
in the figure and disconnect in
reverse order.
1- Turn off all the unnecessary
electrical equipment of the
vehicle.
2- Connect the cables exactly
in the order that is shown in
the figure. First connect the
one end of the first cable to
the positive terminal (+) of the
dead battery (1) and the other
end to the positive terminal of
the booster battery (2). Then
connect the one end of the
second cable to the negative
terminal of the booster battery
and the other end to the fixed
metal point of the vehicle with
the dead battery. Be careful that
the ground connection keep far
from the dead battery.
Make sure not to connect the
negative terminal of the booster
battery to the negative terminal
of the dead battery. Be careful
about the cable ends to be
connected to the proper points.
Do not lean when connecting
the cables.
3- First turn on the engine of the
vehicle with the booster battery
and increase its rpm up to 2000,
then start the engine of the
vehicle with the dead battery.
4- If the discharging cause is
not known (other than staying
on the lamps while the engine
is off), it is necessary for the
vehicle to be checked by an
authorized SAIPA dealer.
Starting the vehicle by pushing
Starting the vehicle by pushing
may cause damage to the
emission control system.
Caution
Do not start the engine by
towing the vehicle.
Because of the sudden motion
of the vehicle toward front
when starting, can cause the
collision of the two vehicles to
each other.
6