SAINT-GOBAIN Norton Clipper BLOCKBUSTER BBM307, Owner'S Manual

Page: 29 / 60

28
OwnersManual-MasonrySaw-BBMSeries-Rev09-2023
Conveyor Cart (Cutting Table) Assembly
The BBM307 Conveyor Cart Assembly is specially designed with the following unique features:
• Dust extraction. The rear of the Conveyor Cart is designed to help extract dust out of the back
of the
• machine when dry cutting.
• Four heavy duty rolling wheels with bearings, roll smooth and provide for a long life.
• Conveyor Cart mounting bracket helps to prevent the Conveyor Cart from falling off the machine
• during use or transportation.
• Conveyor Cart locking pin, locks the cart so it will not move.
Conveyor Cart Locking Pin:
To lock the Conveyor Cart into position when transporting the machine, roll the Conveyor Cart to the
forward most position (see
Figure: Conveyor Cart Assembly ). Then push the lever down and
towards the rail until the Conveyor Cart Locking Pin Engages. The Conveyor Cart may need to be
moved forwards or backwards slightly during this process.
To unlock the Conveyor Cart, reverse the above procedure.
To remove the Conveyor Cart from the machine:
2. Remove the hardware that attaches the Conveyor Cart Mounting Brackets (see Figure:
Conveyor Cart Removal ).
3. Lift the Conveyor Cart off of the rails.
Figure: Conveyor Cart Assembly Figure: Conveyor Cart Removal
Dust/Water Collection Pan
The Dust Collection Pan is assembled to the machine from the factory. The following procedure is
to remove or to replace the Dust Collection Pan Assembly:
1. Remove Conveyor Cart (see Conveyor Cart Assembly page 32 for instructions) and then
remove the four (4) sets of Hardware (Bolt, Lock Washer, and Washer) from each corner of the
machine frame and remove the rails from the frame (see Figure: Removing the Rails).
Note the
orientation of the Hardware and the Rails.
MAINTENANCE