SAINT-GOBAIN Norton Clipper BLOCKBUSTER BBM307, Owner'S Manual

Page: 30 / 60

29
OwnersManual-MasonrySaw-BBMSeries-Rev09-2023
2. Remove the Dust Pan Assembly from the frame (see Figure: Removing the Pan ).
3. Replace the Dust Pan Assembly if required.
4. Replace the Rails (note that the leg with the mounting holes will face towards the outside of
5. the frame.
6. Replace the Hardware. Snug the operator’s left hand side and fully tighten the operators right
7. hand side hardware.
7. Place the Conveyor Cart on the rails (see
Conveyor Cart Assembly page 32 for instructions).
8. Align the Conveyor Cart to the blade by moving the operators left hand rail.
9. After the conveyor cart is aligned to the blade, tighten the left hand rail.
Do not try to remove the Dust Collecting Pan without first removing the Rails.
• Removing the Dust Collecting pan without following the above assembly procedure
will

Damage the Dust Collecting Pan.
Figure: Removing the Rails Figure: Removing the Pan
Right Hand Rail
Left Hand Rail
Dust Colleting Pan
MAINTENANCE BBM307