Removing the Fabric Sample
Cut the thread from the top of the machine and ensure the needle is all the way up. If it is not, raise
the needle by grabbing the top of the balance wheel and rotating toward the front of the machine (
A
).
Never rotate the other direction. Use your knee or hand to push the knee lift (
B
) to the right; this will
lift the feet. Remove the fabric sample while holding the knee lift to the right. Cut the thread coming
from below the machine.
Note: If you want to lock the feet in the up position, push the knee lift to the right and pivot lever (
C
)
into the up position. Release the knee lift and the feet will stay up. Actuate knee lift and lower lever
(
C
) to drop the feet.
29
Lowest
Highest
Auto Lubrication
Fill the oil tray with the oil found in the sewing
machine box. Try to keep the oil level between
the highest and lowest markings on the oil pan
(
29
).
When it becomes necessary to change the oil,
unscrew plug (
F
). Wipe the dirty oil and the dust
from the oil drip pan, replace the plug and add
fresh oil. Use any high-quality, clear sewing
machine oil.
Please proceed to the Fabricator Guidebook.
Leveling the Table
If you find that your table is not level, use a
wrench and loosen nut (
D
) then tighten or
loosen the bolt (
E
) to level out the table. Once
level, tighten the nut.
D
E
F
B
A
28
27
C
23 |
Sailrite.com
Fabricator
®
Assembly Instructions
| 24
Deluxe Fabricator
®
Assembly
Deluxe Fabricator
®
Assembly