15
17
18
Securing the Stitch PRO
Balance Wheel
Remove the three screws (
A
). Position the
C-shaped belt guard (
B
) and reinstall the
screws, making sure washers are positioned as
shims behind the guard to keep it from being
bent out of shape.
Unscrew the reverse-threaded Posi-Pin
®
nut
(
C
). Slide the Stitch PRO Balance Wheel (
D
)
onto the bushing, making sure it does not
interfere with the belt guard. If the wheel hits
the guard, reposition the washers placed
under the C-shaped belt guard or move
the bushing out further by loosening the
set screws in the bushing flange (
E
).
Push the Posi-Pin
®
(
16
) through the
hole in the balance wheel (
F
). While
maintaining pressure on the Posi-Pin,
rotate the balance wheel (
G
) until the
Posi-Pin locks into one of the balance wheel
bushing holes (
H
). Rotation of the balance
wheel will now cause the machine to function.
To disengage the machine (for bobbin winding),
pull the Posi-Pin out of the balance wheel. The
balance wheel will now rotate without operating
the machine. Push the Posi-Pin into the hole at
the center of the Posi-Pin nut (
I
) to store.
Belt Adjustment for the
Workhorse
®
Servo Motor
Before installing the drive belt (
J
), loosen the
screw (
K
) to allow the Workhorse Servo Motor
to freely pivot.
With the machine tilted back, slip the drive belt
over the balance wheel track (
L
) and guide it
onto the motor pulley (
M
) then carefully lower
the machine.
Pivot the motor back to tighten the belt. Proper
adjustment of the belt results in 3/8 inch of
slack when pressed by finger at its center.
Retighten set screw (
K
). The Linkage Bar (
N
)
may need to be readjusted.
Once installed, the belt should not touch the
table and should be centered on the track
of both the balance wheel and motor pulley.
Adjust the positioning of the motor left or right
by loosening the bolts attaching the motor to
the table.
Once the motor is in the correct position and all
bolts are tightened, tilt the machine back and
remove the belt so the pulley bracket can be
installed.
Before Continuing: See “Installing the Pulley
Cover” in the Workhorse instructions.
M
K
J
L
N
G
D
I
F
A
H
C
B
16
E
19 |
Sailrite.com
Fabricator
®
Assembly Instructions
| 20
Deluxe Fabricator
®
Assembly
Deluxe Fabricator
®
Assembly
