Sagem PHOTO EASY 160, User Manual

Page: 12 / 322

- 8 -
T
O CHANGE THE RIBBON
Remark : Use manufacturer consumables only. These are specially designed to provide optimum
print quality.
Switch on the printer. Wait 10 seconds for the printhead to lift, then:
1. Take the smart card supplied with the ribbon and photo paper and insert it in
the reader on the printer's left-hand side. The smart card is recognised and read
by the printer, and once the procedure is complete the wording: "
40 End " or
" 120 End " appears on screen.
2. Remove the SIM card.
3. Take the new ribbon out of its packaging and make sure that the film is
stretched after removing the card ( A ).
4. Open the external flap located on the right-hand side of the printer.
5. Lift the locking lever and remove the used ink ribbon.
6. Install the ribbon in the position shown in the illustration below.
7. Lift the locking lever and push in the film cartridge until it touches the back of
the compartment the locking lever must be locked after insertion.
8. Close the external flap.
Remark : If the ribbon is replaced during a print job, you can resume printing where you left off
by pressing the button.
Liasse AZUR_GB.book Page 8 Jeudi, 21. avril 2005 4:09 16