Sagem MF9300, Operation Manual

Page: 12 / 116

10
ORIGINALS
ORIGINALS THAT CAN BE FAXED
Original sizes
*Long originals
Depending on the resolution setting and the width of the original, there may not be sufficient space in memory to hold a
long original. In this case, refer to the following table and select a lower resolution setting and/or shorten the original.
Scanning area of original
Note that the edges of an original cannot be scanned.
Area that cannot be scanned : 5 mm or less at top edge
and 5 mm or less at bottom edge
: Near edge + far edge = 6 mm or less
Automatic reduction of faxed document
If the width of the faxed document is greater than the receiving machine's maximum receivable width, the document
will be automatically reduced.
A document can also be faxed without reducing its size. In this case, the left and right edges will not be transmitted.
("AUTO RECEIVE REDUCE SETTING" (p.103))
Minimum original size Maximum original size
Using the RSPF 210 mm (width) x 148 mm (length)
148 mm (width) x 210 mm (length) 297 mm (width) x 1000 mm (length)
* Long originals can be loaded.
Using the document glass 297 mm (width) x 420 mm (length)
• Originals that are not a standard size (p.21) can also be faxed.
• There are restrictions on originals that can be scanned using the RSPF. See
"
POINTS TO NOTE WHEN
MAKING COPIES
" in
the operation manual for copier.
A3 wide 297 mm B4 wide 257 mm A4 wide 210 mm
Standard 1000 mm 1000 mm 1000 mm
Fine 1000 mm 1000 mm 1000 mm
Super fine 1000 mm 1000 mm 1000 mm
Ultra fine 880 mm 1000 mm 1000 mm
Faxed document width
Receiving machine's
paper width
Reduced size Ratio
A3 B4 B4 1 : 0.70 (Area ratio)
A3 A4 A4R 1 : 0.5 (Area ratio)
B4 A4 A4R 1 : 0.64 (Area ratio)
Note
Top edge
Near edge
Bottom edge
Far edge
Area that cannot
be scanned