User Manual of HD-TVI Speed Dome
11
⧫
Angle Zero Configuration
Purpose:
You can define the angle zero of the speed dome on the
ANGLE ZERO
submenu.
Steps:
(1)
Move the cursor to
ANGLE
ZERO
using the direction buttons and click
IRIS+
to enter.
(2)
Click the left/right/up/down direction buttons to adjust the monitor angle of the speed dome.
(3)
Click
IRIS+
button to confirm the settings and exit.
⧫
Display Settings
Purpose:
You can enable or disable the on-screen display of PTZ movements, alarms, time, presets, zone,
address, error rate, and fan/heat show, etc.
Steps:
(1)
Move the cursor to
DISPLAY SETTINGS
using the direction buttons and click
IRIS+
to enter.
(2)
Move the cursor to the target item and click
IRIS+
and click up/down direction buttons to
choose each display mode as
ON
or
OFF
, and define each display time as 2 seconds, 5 seconds
or 10 seconds.
(3)
Click
IRIS+
button to confirm the settings.
If you enable the OSD for both
ZOOM RATIO
and
P/T ANGLE
, while calling a preset, the preset
No. will be displayed on the screen till the preset scene passes.
DISPLAY SETTINGS
ZOOM RATIO ON
P/T ANGLE ON
ALARM OFF
TIME ON
PRESET LABEL ON
ZONE OFF
BACK EXIT
DISPLAY SETTINGS
ADDRESS OFF
ERROR RATE OFF
FAN/HEAT OFF
BACK EXIT
Figure 3-6
Display Settings
The speed dome shows the viewing direction when you manually control it to rotate.
Table 1-1
Viewing Direction Display
Display
N
NE
E
SE
S
SW
W
NW
Indication North Northeast
East
Southeast South Southwest
West
Northwest
The north direction refers to the angle zero.
⚫
Heat Parameter Configuration
You can set the
HEAT CONTROL
as
TEMP
(controlled by the temperature),
ON
or
OFF
.
