Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE:
If the latch plate
ends up just at the belt path
opening so you cannot grasp
the vehicle belt at the latch
plate, grasp the vehicle belts on the opposite side of the child
restraint, as close to the latch plate as possible. Install the
locking clip on the latch plate end, as close as possible.
Tighten Vehicle Belt
Push down firmly on the base
and pull up on the shoulder
belt to tighten
2.
3.
D. General Vehicle Installation
37
38
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s latch plate.
Rebuckle vehicle belt.
5.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
4.
6.
Check Vehicle Belt
Tightness
Grasp the base at the
vehicle belt path
with
one hand. Push and pull
the base from side to side,
forward and back. The base
should not move more than
1 inch.
NOTE:
If base moves more than 1 inch, redo all of the steps or
try another seating location.
Remove the locking clip when the vehicle seat belt is not
being used with a child restraint.
7.
Same steps apply for use
on the child restraint. See
section E-6 for vehicle belt
step by step installation.
NOTE:
The carrying handle
can be in any locked position
when installed in the vehicle.
4358-6459A SF Onboard 22.indd 39-40
4358-6459A SF Onboard 22.indd 39-40
9/5/14 4:27 PM
9/5/14 4:27 PM
