Prepare the Device for Operation
Chapter 3. Configuration
19
Figure 3-1
Management Port and Network Management Station on Different Subnets
Example
This example configures the default gateway for Router #1 in Figure 3-1. The
example enters configuration mode for the management interface, assigns a
default gateway IP address, and saves the configuration. In this example, the
management interface is configured through the RS-232 craft port.
admin>
configure terminal
config>
interface management
config-ifMan>
ip address 192.168.10.1 255.255.255.0 192.168.10.1
config-ifMan>
exit
config>
exit
admin>
copy system:running nvram:config
Prepare the Device for Operation
Configure the Remote Interface
Follow the procedures described in this section to configure the HA4000 for
operation. The HA4000 can be configured through the CLI, which can be accessed
through the serial port or through the management port.
Save configuration settings when you complete configuring the HA4000 or after
entering each command. When the HA4000 is rebooted or the power is recycled,
unsaved configurations are lost.
Configure these components on the remote interface:
z
Remote port IP address and subnet mask
z
Auto-negotiation and flow control
z
Default gateway for IKE negotiation traffic
