19
XL-FW535 Rev G · 2014-08-11 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF, and
logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Rebuild Procedures
Figure 28
Figure 27
9. Release Cam Pivot Bolt Installation
1. To complete installation of the release cam, refer to
Figures 27 and 28
for the following three (3) steps:
a. Place one 1/2" I.D. x 2-1/4" O.D. washer between
the tapped boss of the top plate and the bottom of
the release cam, with the rounded side of the washer
toward the release cam, and align the hole with the
tapped boss of the top plate.
b. Position the release cam bushing within the release
cam slot and place the remaining 1/2" I.D. x 2-1/4"
O.D. washer on top of the bushing and release cam,
with the rounded side of the washer toward the
release cam, and align the holes over the tapped boss
of the top plate.
c. Secure the assembly by inserting the 1/2"-20 x 1-3/4"
hex head cap screw through the washers and release
cam bushing, into the tapped boss of the top plate
and tighten to 40-50 ft.-lb. (54-68 N•m).
NOTE:
Be sure the threads of the hex head cap screw
have a thread-locking compound.
RELEASE CAM
BOSS WITH
TAPPED HOLE
RELEASE CAM BUSHING
RELEASE CAM
WASHER
WASHER
HEX HEAD CAP SCREW
