16
XL-FW535 Rev G · 2014-08-11 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF, and
logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Figure 22
Figure 21
Figure 20
Rebuild Procedures
5. Refer to
Figure 20
for the following three (3) steps:
a. Insert the M12 x 1.75 x 40 mm hex head cap screw
through the aligned holes of the release handle and
release cam with the bolt head toward the top plate.
b. Place the release cam bushing and the hardened steel
washers, in order as illustrated, over the hex head
cap screw.
c. Secure the assembly with the M12 x 1.75 lock nut and
tighten to 40-50 ft-lbs (54-68 N•m).
6. Position the release handle to allow room for securing
the air cylinder pickup to the release handle using the
1/4"-20 x 5/8" hex head cap screws
(Figure 21)
.
Tighten to 7-9 ft-lbs (9.5-12 N•m).
7. Lubricate the release handle and air cylinder pickup in
areas illustrated
(Figure 22)
.
RELEASE CAM
HANDLE
RELEASE CAM BUSHING
M12 x 1.75 LOCK NUT
M12 x 1.75 x 40 mm
HEX HEAD CAP SCREW
1/4"-20 x 5/8"
HEX HEAD CAP SCREWS
AIR CYLINDER
PICKUP
LUBRICATE
LUBRICATE
1/2" I.D. x 1" O.D.
HARDENED STEEL WASHER
5/8" I.D. x 1-1/4" O.D.
HARDENED STEEL WASHER