13
XL-FW535 Rev G · 2014-08-11 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF, and
logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Rebuild Procedures
Figure 13
Figure 12
FIRST ADJUSTMENT
NOTCH
ADJUSTING
PIN
1-3/8" DIA
RETAINING RING
LOCK PIN
LOCK
HOOK
SHIM
RINGS
8. Align the hook and insert the adjusting pin so that it
lines up with the first adjustment notch
(Figure 12)
.
The adjusting pin will turn counter-clockwise to adjust.
9. Place the 1-1/8" diameter retaining ring on the adjusting
pin
(Figure 13)
. Shim rings may be used to reduce the
gap between the bottom plate and the adjusting pin
retaining ring. Two (2) shim rings are included in rebuild
kits RK-AL-A-L, RK-AL-A-L-MET, and RK-AL-A-80-L,
if needed.
10. Align the lock, insert the lock pin and install the 1-3/8"
diameter retaining ring to secure lock pin
(Figure 13)
.
ADJUSTING PIN
1-1/8" DIA
RETAINING RING