Saeco NINA, Operating Instructions Manual

Page: 9 / 24

• 9 •
English
5.1 Using Ground Coffee
• (Fig.7) - Insert the pin (13) into the pressurized porta fi lter
(10).
• (Fig.8A) - Insert the "Crema perfetta" fi lter for ground
coffee (11).
• (Fig.11) - Insert the porta fi lter into the brew unit from the
bottom (6).
• (Fig.12) - Turn the porta fi lter from left to right until it locks
in place.
• (Fig. 14) - Preheat the pressurized porta fi lter by switching
the selection knob (17) to the " " position until some
water spills out of it. This is to be done only for the fi rst
coffee brewing.
• When 50cc of water have fl owed out, switch the selection
knob (17) to the " " position in order to stop brewing.
• (Fig.16) - Remove the porta fi lter from the machine by
turning it from right to left and drain any water left. There
is no need to change the fi lter to make one or two coffees,
since the machine is equipped with a special fi lter (11).
• (Fig.9A) - Add 1- 1.5 measuring scoop for single coffee
and 2 measuring scoops for double coffee. Remove any
coffee residues from the rim of the fi lter.
• (Fig.11) - Insert the porta fi lter (10) into the brew unit from
the bottom (6).
• (Fig.12) - Turn the porta fi lter from left to right until it locks
in place.
• (Fig.13) - Take 1 or 2 preheated cups and place them
under the pressurized porta fi lter. Make sure that they are
correctly placed under the coffee dispensing holes.
• (Fig.14) - Turn the selection knob (17) to the " "
position.
• When the desired quantity of coffee has been obtained,
turn the selection knob (17) to the " " position in order
to stop coffee brewing. Wait a few second after brewing
has stopped, then remove the cups of coffee (Fig. 15) .
• (Fig.16) - Remove the pressurized porta fi lter and empty
the remaining coffee residues.
Note: If a small quantity of water remains in the
porta fi lter; this is absolutely normal and is due
to the porta fi lter features.
Important note: The "Crema Perfetta" filter
should be kept clean to guarantee perfect
results. Clean daily after use. If you experience a
malfunction in the coffee brewing process, leave the
fi lter in a container of hot water for 30 minutes, then
rinse under running water and try again.
5.2 Using Coffee Pods
• (Fig.10) - Use a coffee spoon to remove the "Crema
perfetta" fi lter for ground coffee (11) from the pressurized
fi lter holder (10).
• (Fig.7) - Insert the pin (13) into the pressurized fi lter holder
(10).
• (Fig.8B) - Insert the "Crema perfetta" fi lter for pods (14)
into the pressurized fi lter holder (10).
• (Fig.11) - Insert the porta fi lter into the brew unit from the
bottom (6).
• (Fig.12) - Turn the porta fi lter from left to right until it locks
in place.
• (Fig. 14) - Preheat the pressurized porta fi lter by switching
the selection knob (17) to the " " position until some
water spills out of it. This is to be done only for the fi rst
coffee brewing.
• When 50cc of water have fl owed out, switch the selection
knob (17) to the " " position in order to stop hot water
dispensing.
• (Fig.16) - Remove the pressurized porta fi lter from the
machine by turning it from right to left. Be careful not to
remove the fi lter.
• (Fig.9B) - Insert the pod into the porta fi lter and make sure
the paper of the pod does not overhang the porta fi lter.
• (Fig.11) - Insert the porta fi lter into the brew unit from the
bottom (6).
• (Fig.12) - Turn the porta fi lter from left to right until it locks
in place.
• Take 1 preheated cup and place it under the porta fi lter;
make sure that it is correctly placed under the coffee
dispensing holes.
• (Fig.14) - Turn the selection knob (17) to the " "
position.
• When the desired quantity of coffee has been obtained,
turn the selection knob (17) to the " " position in order
to stop coffee brewing, then remove the coffee cup.
• (Fig.16) - Wait a few seconds after brewing, then remove
the porta fi lter and dispose of the used pod.
Important note: The "Crema Perfetta" filter
should be kept clean to guarantee perfect
results. Clean daily after use. If you experience a
malfunction in the coffee brewing process, leave the
fi lter in a container of hot water for 30 minutes, then
rinse under running water and try again.