• 32 •
Machine Installation - Service Provider Manual
10.4 Setting the PASSWORD
The PASSWORD must be set by the service provider in order to
prevent access by unauthorised personnel who could change the
machine settings and cause malfunctions.
To set the PASSWORD, proceed as follows:
1
Switch to programming mode as described in section 10.1.
YELL
OW
2
Press the “
” button (24) until the following menu is dis-
played:
PASSWORD
YELL
OW
3
Press the
"
"
button (18) or the "
" button (20) to select
"YES".
PASSWORD
YELL
OW
4
Press the "
" button (24) to confi rm.
PASSWORD
CHANGE PSW
YELL
OW
5
The option "CHANGE PSW" will be displayed, which will allow
the password to be set.
6
Press the “
” button (21) to confi rm and to set the pass-
word.
SET PSW
CONFIRM
0 0 0 0
YELL
OW
To enter the password:
7
Press the
"
"
(18) or "
" (20) button to set the desired
number.
8
Press the “
” button (24) to move on to the next number
(when it gets to the end it will start again from the beginning).
9
Repeat steps 7 and 8 until the set password has been entered.
10
Press the "
" button (21) to confi rm the password and to
exit the menu.
Note: You can exit the change menu at any time
without saving the setting by pressing the “
”
button (22).
Note: If "NO" is selected from the "PASSWORD"
menu, the saved password will be cancelled.
PASSWORD
YELL
OW
