Saeco IDEA RST Series, Operation And Maintenance

Page: 85 / 228

English
7
85
The grinding is pre-set by the manufacturer on standard
values, but it can be changed with the following procedure:
• Open the door, rotate the knob counter-clockwise to set
a finer grind (the notch moves on a lower value), or
clockwise to set a coarser grind (the notch moves to a
higher value). Use the 10 mm wrench supplied as an
accessory to perform adjustment.
P Adjustment knob
S Door
7.6 First Appliance Start-up
• Check if the removable components are correctly placed
and if the door is closed.
Otherwise, when the machine is switched-on, the display
will indicate which component is in the wrong position.
• Refill the appliance (follow the instructions above) and
connect the plug to the electric network (see section
“Connection to the Electric Network”).
• Turn the all-pole switch to “I”.
• Switch on the machine by means of the power button.
The message “HEATING WAIT” will be displayed.
Once the warm-up phase is over, the display will show:
“READY FOR USE”.
• Adjust the dispensing spout so as to obtain the suitable
height for the containers used.
• Place one or two containers under the dispensing spout.
• Press the button corresponding to the beverage selected.
Although all buttons are
previously programmed on
standard values, check if
the
dispensed beverage
has the desired features.
If not, brew buttons must
be
reprogrammed (see
chapter “Brew Buttons
Programming”).
7.7 Washing the Parts coming into
Contact with Food
Wash all appliance parts coming into contact with food.
• Thoroughly wash your hands.
• Prepare a chlorine-based, antibacterial disinfecting solution
(the products can be purchased at the chemist's) following
the concentrations indicated on the product.
• Remove all product containers from the appliance.
• Remove the container lids and product chutes. Immerse
all these parts in the previously prepared solution.
7.8 Using the Appliance
The beverage selection modes are indicated in chapter
"Operation and Use".