Saeco auLika, Operating Instructions Manual

Page: 28 / 62

• 22 •
Machine Installation - Service Provider Manual
8.4 Assembly-Siting
The machine must not be installed outdoors or in
environments in which jets of water or steam are
used.
The presence of magnetic fi elds or proximity to
electrical machines which generate disturbances
could cause the electronic controls of the machine to
malfunction. At temperatures close to 0°C, internal parts
containing water are at risk of freezing. Do not use the
machine under these conditions.
To ensure correct and effi cient performance of the appliance,
comply with the following recommendations:
• Room temperature: 10°C ÷ 40°C;
• Maximum humidity: 90%;
• The site should be suitably prepared for the installation of the
machine;
• The surface on which the machine is installed should be level,
solid and stable, with a gradient of max 2°;
• The location should be adequately lit, ventilated and clean,
and the power socket should be easily accessible.
Access to the machine and the plug should be kept
clear at all times, in order to allow users to easily
reach them and to leave the area immediately if required.
The following illustration shows the required access distances:
• To the keypad on the front of the appliance
• To the service units in the event of malfunction.
The machine consists of 2 parts packed in 2 diff e-
rent packages and which should be assembled as
described in section 8.6.
After placing the packing container near the installation site, pro-
ceed as follows:
• Ensure that the container has not been tampered with during
transport and that the original packaging is intact and closed;
• Open the container;
• Check the condition and model of the machine;
• Check the contents of the accessories bag enclosed with the
machine (see "8.3 List of Accessories Supplied");
• Remove the machine from its original packaging;
• Remove any remaining packaging from the machine;
• Lift the machine and place it in the designated area.
8.5 Disposal of Packaging
After opening the package, it is recommended that the packaging
materials are separated according to type and disposed of in ac-
cordance with the regulations in force in the country of use.
We recommend keeping the container for future
transfers or transportation.
8.6 Installing the Container Base
The containers have to be installed at the base of the machine
before starting to use the appliance.
1 Remove the drip tray and the group compartment drawer to
be able to install the containers.