Saci VSD magnus, Installation And Maintenance Manual

Page: 34 / 164

ENGLISH
34
10 SETUP MENU
6 DISPLAY
Par Description Units
VALUES
Notes
Default Min. Max.
6.7 Digital input 2
Indicates whether input 2 is enabled or not;
if it is enabled, the reason for this.
6.8 Relay 1 output
Indicates whether relay 1 is enabled or not;
if it is enabled, the reason for this.
6.9 Relay 2 output
Indicates whether relay 2 is enabled or not;
if it is enabled, the reason for this.
6.10 Software version
Indicates the version of the software of the
control panel (screen) and the power panel
(aluminium radiator).
6.11 Power consumed by pump W
Indicates the instantaneous power
consumed by the pump.
6.12 Power consumed by network W
Indicates the instantaneous power
consumed by all the pumps that are
operating at that time.
7 LOG
Shows a log of anomalies of the pump where the speed variator is connected, indicating the date, the time
and the anomaly that occurred. This information is very important for detecting possible anomalies in the
functioning of the installation.
8 INPUTS OUTPUTS
Par Description Units
VALUES
Notes
Default Min. Max.
8.1 Digital input 1
Unused
Unused /
Emergency
stop / Forced
start
An input can be enabled to carry out a
remote stop or to force the pump to start,
even though it is out of reach of a filtration
cycle.
Important: Input 1 is a normally open input,
therefore to enable it the contact must be
closed without voltage.
8.2 Input 1 frequency Hz 50 10 50
If digital input 1 is activated for forced
operation, you can indicate the frequency at
which you want the pump to function when
the input is enabled.
8.3 Digital input 2 Unused
Unused /
Emergency
stop / Forced
start
A second input can be enabled to carry out
a remote stop or to force the pump to start,
even though it is beyond the scope of a
filtration cycle.
Important: Input 2 is a normally open input,
therefore to enable it the contact must be
closed without voltage.
8.4 Input 2 frequency
Hz 50 10 50
If digital input 2 is activated for forced
operation, you can indicate the frequency at
which you want the pump to function when
the input is enabled.
VSD Magnus - [e]Magnus
VSD Magnus - [e]Magnus