TAIL BELT TENSION
*Check the proper assembly of the tail boom.
*Check that the aluminum part of the tube is against the M3 stop screw.
*Loosen the tail group by loosening the 4 M3 screws.
*Install the belt onto the pulley, taking care to respect the direction of rotation (
figure 1
).
*Rotate the tail drive several times by hand.
*Load the spring by a rotation of
270°
the tensioning arm (
clockwise
)
*Tension the boom until the tensioning arm is aligned with the frame.
*Tighten the 4 screws.
*Check that the tail output shaft is perpendicular to the tube. (
figure 2
)
*In
figure 3,4,
5 you can see the three conditions, ok, too loose and too tight.
NOTE
. To disassemble the tail boom it is possible to remove the pulley H0016-S without loosening the tail unit.
Remove the locking screw and pull down.
Canopy
Red Canopy code: H0164-S - Yellow Canopy cod: H0148-S.
On the Goblin, the canopy touches the frame. To avoid triggering vibration, it is necessary to
attach an adhesive foam tape to the canopy
HA006
[
Bag 14
] (
figure 6
).
The canopy is locked at the point shown in
figure 8
and with two
H0036
kobs (both equipped
with OR
HA008
[
Bag 14
] (
figure 7
)). Confirm the canopy is secure prior to each flight.
Copyright@2012 - SAB Heli Division - All rights reserved
Page 31
Chapter 13, Installation Of The Boom, Canopy
