DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
There are two mounting options:
Mount using part # H0004 (ESC Aluminum Support)
Typically used for Kontronik Jive 120. The speed controller is placed on top of the aluminum support. (Fig. 1)
Mount using part #H0153 (ESC Carbon Support) (Fig. 2)
Typically used for ESCs with aluminum cases, such as Kontronik Kosmik (Fig. 3). The speed controller is attached under the
carbon fiber plate.
A heat sink upgrade is available for the YGE 160 controller (Part #H0165-S) (Fig. 4)
Figure 5
: Shows the wiring which connects the receiver and ESC (in this picture one frame has been removed).
If the BEC used is combined with the ESC, it is recommended to use a dual wire connection.
Figure 6
: The passage of the controller wires to the motor is highlighted.
Figure 7
: Shows the installation of a 2S battery for the flight control system.
Alternatively, a BEC could be placed in the same area.
ESC Cables
2S Battery or BEC
Copyright@2012 - SAB Heli Division - All rights reserved
Page 26
Chapter 10, Installation Of The ESC
