R60 Station
R60 User Manual
Document Number
Version
Date
7000 120-019
A1
2022-08-10
Page 22 (98)
2.
Make sure the base station is connected to a TCP/IP network using port 3 and
reachable from the computer where the web GUI shall be accessed.
3.
Open your web browser.
4.
In the browser address field, type in the ETH3 IP address in the format
xxx.xxx.xxx.xxx and press Enter.
If your browser can access the R60 supervisor unit, and if you have used the correct IP
address, the web GUI start page will now appear. The start page displays as shown in
Figure 3-1.
3.5
Introduction to the R60 web interface
The web GUI is used for setting parameters and monitoring operation of the R60
Station.
The GUI is a web site, and similarly to any site on internet it consists of a start page and
sub-pages. The site and its pages are divided into four main categories:
HW/SW Info, shows software, hardware and license information.
More information is found in section 4.
Monitor, used for monitoring the operation of an R60.
More information is found in section 5.
Configure, used for configuring the R60.
More information is found in section 5.5.
Maintenance, used for upgrading the R60 software and/or firmware.
More information is found in section 7.
The first page reached when accessing the web site (the home page) is shown in Figure
3-1 below. It displays the four main categories, while for some categories there are
also sub-categories (sub-pages).
