Ryobi WS730, Operator'S Manual

Page: 10 / 56

10 — English
UNPACKING
This product requires assembly.

Carefully lift the saw from the carton and place on a level
work surface.

Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.

Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.

The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental start-
ing and possible serious personal injury.
INSTALLING MOTOR HEAD ASSEMBLy TO
FRAME
See Figure 6, page 19.

Align the holes in the motor head assembly with the holes
on the side of the water tray frame.
ASSEMBLy

Insert large and small socket head screws and finger
tighten.

Using the hex key, securely tighten the large socket head
screws on the side of the water tray frame.

Tighten the small socket head screws last.
INSTALLING END-OF-CUT REMINDER
See Figure 7, page 19.
The end-of-cut reminder has two purposes: 1) to keep the
garden hose secure and out of the way, and, 2) to slow down
the Easy Glide Table™ to help prevent tile from cracking
and chipping.

Align the hole in the end-of-cut reminder with the hole in
the inside of the back of the water tray frame.

Using a screw, secure the end-of-cut reminder in place.
INSTALLING SPLASH GUARD
See Figure 8, page 20.

Align the hole in the splash guard with the hole in the
back of the motor head assembly.

Using the flat washer and screw, secure the splash guard
in place.
INSTALLING WATER SUPPLy VALVE TO THE
WATER TRAy
See Figure 9, page 20.

Unscrew the water supply valve cap.

Place the water supply valve into the hole in the water
tray as shown in figure 9.

Screw the water supply valve cap onto the threaded end
of the valve and tighten securely.
INSTALLING TILE SAW TO THE WATER TRAy
See Figure 9, page 20.

Carefully place the water tray frame inside the water tray.
Saw head assembly goes to the back of the frame where
the hose connections are located.
PUMPLESS FLOW SySTEM™ - The pumpless flow system
sprays clean, fresh water on blade for trouble-free cutting.
This fully enclosed water system keeps internal cords and
hoses dry and securely out of the way.
RIP GUIDE -
Rip guide is fully adjustable for straight and
miter cuts.
FEATURES
SPLASH GUARD - The splash guard provides protection
from overspray and mist.
UPPER WHEEL GUARD
- Protects user from wheel contact
on upper portion of wheel.