![background image](http://html1.mh-extra.com/html/ryobi/ws730/ws730_operators-manual_1506699014.webp)
14 — English
OPERATION
Using a marker or grease pencil, mark the area to be cut
on both sides of the material.
Set the rip guide to the desired setting, lock in place, and
tighten the lock knob.
Place the material on the table and firmly against the rip
guide and fence.
Make sure the material is clear of the cutting wheel before
turning on the saw.
Turn the on/off switch to the
ON
position.
Turn the flow adjustment valve to the
ON
position.
Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
Hold the material firmly against the rip guide and feed
the material into the cutting wheel.
Make the cut far enough into the material without over-
cutting.
Turn the material over and make the cut along one of the
marks. This time overcut the other line and the cut piece
should separate from the rest of the material.
When the cut is made, turn the saw
OFF
. Wait for the
cutting wheel to come to a complete stop before remov-
ing any part of the material.
TO MAKE A BEVEL CUT
See Figure 26, page 23.
Beveled 45° cuts can be made with the bevel block.
Using a marker or grease pencil, mark the area to be cut
on material.
Place the bevel block on the right side of the table at the
desired distance from the wheel and lock in place.
Place the material on the bevel block.
Make sure the material is clear of the cutting wheel before
turning on the saw.
Turn the on/off switch to the
ON
position.
Turn the flow adjustment valve to the
ON
position.
Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
Hold the material firmly against the bevel block and fence
and feed the material into the cutting wheel.
When the cut is made, turn the saw
OFF
. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
Summary of Contents for WS730
Page 54: ...24 NOTES NOTAS...
Page 55: ...25 NOTES NOTAS...