![background image](http://html1.mh-extra.com/html/ryobi/rts23/rts23_operators-manual_1506614019.webp)
19 - English
ASSEMBLY
TO OPEN/CLOSE (SET-UP/TEAR DOWN) THE
LEG STAND
See Figure 15.
NOTE:
Use the cord wrap on the end of the saw to keep the
cord out of the way when setting up or tearing down the saw.
To open (set-up) the leg stand:
Step 1:
Stand the saw on the wheeled end. Open the
latch and unhook it from the crosspiece. Lay the leg
sections flat.
Step 2:
Grasp the inner stand support bracket and lift
it until it meets the saw frame. Hook the latch over the
inner stand support bracket and push down until the
latch locks.
Step 3:
Make sure the table extension is in the locked
position. Set your right foot against the saw leg to steady
it while you push downward on the top leg and lift the
saw frame to set the saw upright.
To close (tear down) the leg stand:
Step 1:
Standing to the side of the table saw, place your
foot against the foot of the saw. Hold the saw table and
grasp the upper saw leg. Make sure the table extension is
in the locked position. Tilt the saw to your left and lower
the saw to the floor until it is balanced on end.
Step 2:
Open and release the latch. Allow both leg
sections to lie flat.
Step 3:
Grasp the crosspiece and lift both leg sections
so that the crosspiece meets the latch. Hook the latch
into the crosspiece and push the latch back until it locks.
Fig. 15
SET-UP
TEAR-DOWN
Summary of Contents for RTS23
Page 147: ...NOTES NOTAS...