![background image](http://html1.mh-extra.com/html/ryobi/rts23/rts23_operators-manual_1506614044.webp)
44 - English
DADO CUT
OPERATION
MAKING A DADO CUT
See Figure 61.
An optional dado throat plate is required for this procedure
(see the
Accessories
section of this manual and check with
the retailer where the table saw was purchased). All blades
and dado sets must not be rated less than the speed of this
tool. This saw is designed for use with a 6 in. stack dado
(up to width of 1/2 in.). Do not use an adjustable dado or
molding cutters on this saw.
Rabbeting cuts are dado cuts made on the end of a
workpiece. For best results, complete rabbet cuts using a
dado stack blade.
NOTE:
Use an auxiliary fence when making rabbet cuts to
prevent the face of the rip frence from making contact with
the dado blade stack during the cutting operation.
WARNING:
When making a non-through cut, the blade is covered
by the workpiece during most of the cut. Be alert to
the exposed blade at the start and finish of every cut to
reduce the risk of personal injury.
WARNING:
Always put all blade washers in proper location when
reinstalling standard blade. Failure to do so can result in
possible injury and damage to the tool.
WARNING:
Always use push blocks, push sticks, and/or featherboards
when making dado cuts to avoid the risk of serious injury.
Unplug the saw.
Remove the blade guard, throat plate, and riving knife.
NOTE:
For details on removing and reinstalling the riving
knife, see
Cleaning the Riving Knife Lock Lever Plates
in the Maintenance section of this manual.
Remove the blade nut, blade washer, and saw blade.
NOTE:
Always store the blade washer and throat plate
in a secure location.
Mount the dado blade, according to manufacturer
instructions, using the blade and chippers appropriate
for the desired width of cut.
Reinstall and securely tighten the blade nut.
NOTE:
The blade washer may be used provided the arbor
shaft extends slightly beyond the arbor nut.
Make sure the blade nut is fully engaged and the arbor
extends past a securely tightened blade nut.
Place release lever in locked position.
Install the dado throat plate and rotate the blade by hand
to make sure it turns freely then lower the blade.
Depending on the shape and size of the wood, use either
the rip fence or miter gauge.
If making a rip cut, install featherboard in the appropriate
position for the cut being made.
Turn the saw on.
NOTE:
Make sure the wood does not touch the blade
before you turn on the saw. Let the blade build up to full
speed before feeding the workpiece into the blade.
Position the workpiece flat on the table with the edge
flush against the rip fence or miter gauge and hold firmly
against the saw table.
Use a push block or push stick to move the wood through
the cut past the blade. Never push a small piece of wood
into the blade with your hand, always use a push stick.
The use of push blocks, push sticks, and featherboards
are necessary when making non-through cuts.
When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
NOTE:
A dado cross cut is shown in the illustration above. To
make a dado rip cut, remove the blade guard, anti-kickback
pawls, throat plate, and riving knife. Install the dado blade
and dado throat plate then perform the rip cut, see
Making
a Rip Cut
earlier in this section.
Once all dado cuts are completed:
Unplug the saw.
Remove the dado throat plate and dado blade.
Reinstall the riving knife in the “up” position.
Reinstall standard cutting blade, throat plate, and blade
guard.
BLADE GUARD
REMOVED
MITER
GAUGE
Fig. 61
Summary of Contents for RTS23
Page 147: ...NOTES NOTAS...