![background image](http://html1.mh-extra.com/html/ryobi/rts23/rts23_operators-manual_1506614032.webp)
32 - English
Fig. 42
OPERATION
FRONT RAIL
Fig. 41
Fig. 40
TO USE THE RIP FENCE
See Figure 40 - 41.
WARNING:
To reduce the risk of injury, always make sure the rip fence
is parallel to the blade before beginning any operation.
NOTE:
The rip fence included with your saw has a low fence.
The low fence should face away from the blade when cutting
material greater than 3/4 inches thick. The low fence should
face toward the blade when cutting thin and/or narrow
workpieces.
NEVER
support the weight of the workpiece
on the low fence while making a cut.
Loosen the rip fence by lifting the locking lever.
Place the rear lip on the rear of the saw table and pull
slightly toward the front of the unit.
Lower the front end of the rip fence onto the guide
surfaces on top of the front rail.
Check for smooth gliding action.
Position the rip fence the desired distance from the blade.
With the rip fence flat on the saw table, push the fence
towards the front rail to align the fence to the blade.
Push the locking lever down to align and secure the
fence. When securely locked, the locking lever should
point downward.
NOTE:
Ensure the locking lever secures the rip fence
in place. If adjustments are needed, see
To Check
the Tightness of the Rip Fence Locking Lever
in the
Adjustment
section of this manual.
NOTE:
If the rip fence is not parallel to the blade,
adjustments are needed. Refer to:
To Check the Alignment
of the Rip Fence to the Blade
in the
Adjustment
section
of this manual.
TO SET THE RIP FENCE SCALE INDICATOR
TO THE BLADE
See Figure 42.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE:
The blade guard must be removed to perform this
adjustment. Reinstall the blade guard when the adjustment
is complete.
Begin with the blade at a zero angle (straight up).
Unplug the saw.
Loosen the rip fence by lifting the locking lever.
Using a framing square, set the rip fence 2 in. from the
blade tip edge.
Loosen the screw on the scale indicator and align with
the 2 in. mark as shown.
Tighten the screw and check the dimension and the rip
fence.
BLADE
RIP
FENCE
LOCKING LEVER
2 in.
MARK
SCALE
INDICATOR
RIP FENCE
2 in.
SCREW
SCALE
LOCKING
LEVER
REAR OF
SAW TABLE
REAR
LIP
LOW
FENCE
RIP
FENCE
FRONT
RAIL
Summary of Contents for RTS23
Page 147: ...NOTES NOTAS...