5
English (Original Instructions)
Fig 11
34. Start
35. Choke
36. Run
37. Recoil starter
Fig 12
38. Engine switch
Fig 13
39. Slot
40. Lock out
Fig 14
41. Nozzle
42. Quick-connect collar
43. Spray wand
44. “Click”
Fig 15
45. Trigger
Fig 16
46. Injection hose
47. Detergent container
ASSEMBLY
UNPACKING
This product requires assembly.
n
Carefully cut the box down the sides then remove
the tool and any accessories from the box.
n
Inspect the pressure washer carefully to make sure
no breakage or damage occurred during shipping.
n
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
pressure washer.
n
If any parts are damaged or missing, do not operate
the pressure washer and contact Ryobi Customer
Service for assistance.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
To attach the wheels to the pressure washer base:
n
Locate the axle, axle sleeves, hitch pins, washers,
and wheels. Remove the hitch pin from the axle.
n
Slide the axle through the axle sleeve, then slide
both through the hole in the centre of the wheel.
n
Slide the washer onto the axle.
n
Lift the machine and slide the axle into the wheel
mounting hole in the machine base as shown.
n
Push the hitch pin into the hole on the end of the
axle to secure the wheel assembly.
NOTE:
The hitch pin should be pushed into the axle until
the centre of the pin rests on top of the axle.
n
Repeat with the second wheel.
LIFTING AND FOLDING THE HANDLE
See Figure 3.
To lift the handle:
n
Lift and hold the handle up.
n
Lock the handle in position by pulling up the left and
right latches until they snap into place.
To lift the handle:
n
Hold the handle.
n
Unlock the handle by pushing down the left and
right latches.
n
Hold down and fold the handle to its original
position.
ADDING LUBRICANT TO THE ENGINE
See Figure 4.
CAUTION:
ANY ATTEMPT TO START THE ENGINE
WITHOUT ADDING LUBRICANT WILL RESULT
IN ENGINE FAILURE.
n
Place pressure washer on a flat, level surface.
n
Unscrew and remove the oil cap / dipstick by turning
counter clockwise and wipe it clean.
n
Insert the oil cap / dipstick into the oil filler neck but
do not screw it in. Then remove to check the oil
level.
n
Using 4-stroke engine lubricant (SAE 30 or SAE
10W30) and a funnel, fill to the upper limit mark
of the oil cap / dipstick. Do not overfill. (4-stroke
engine lubricant provided).
n
Replace the oil cap / dipstick and securely tighten.
NOTE:
This engine has a total lubricant capacity of
600ml.
ADDING PETROL TO THE FUEL TANK
See Figure 5.
WARNING:
Petrol and its vapours are highly flammable and
explosive. To prevent serious personal injury and
property damage, handle petrol with care. Keep
away from ignition sources, handle outdoors only,
do not smoke while adding fuel, and wipe up
spills immediately. When adding petrol to the
