OPERATION
NOTE:
Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from the receptacle.
NOTE:
Use only approved outdoor extension
cords.
NOTICE:
Always use cord retainer to properly
attach extension cord to string trimmer. Failure to
use cord retainer may result in damage to string
trimmer and/or extension cord.
STARTING/STOPPING THE TRIMMER
Squeeze the On/Off trigger (Fig.7) to start the
grass trimmer. To stop the Grass Trimmer, simply
release the trigger.
WARNING.
The motor will continue to
run for approximately 5 seconds after it
has been switched off. Let the motor
come to a complete stop before setting
the tool down.
EXTENDING THE LINE
As the grass trimmer is used the cutting line will
become worn down and less efficient. To increase
the length of the cutting line with the grass trimmer
running, bump the centre button in the cutting line
spool, Fig.8, on the ground. This will release more
cutting line which will be cut to the correct length by
the blade fitted in the cutting head guard.
The line will be cut to the correct length by the
cutting blade, Fig.9 everytime the cutting head is
started.
Note: You will need to exert a certain force to pull
out the line when the trimmer is used for the first
time. To do so, press on the push button and pull
out the line as far as the edge of the grass
deflector.
PREPARING TO WORK
CHECKING THE TOOL
Ensure that the strimmer is not connected to a
power supply.
Before starting work please:
Check that the trigger switches and the safety
switch should move freely without forcing and
return automatically and rapidly back to their
neutral position;
Check that the cooling air vents are not obstructed;
Check that hand grips and protection devices are
clean and dry, correctly mounted and well fastened
to the tool;
Check that the tool is not showing signs of wear or
damage due to knocks or other causes, and carry
out the necessary repairs.
Check that the mains cable is in good working
condition and there are no signs of damage.
Never use the tool with a damaged or worn mains
cable.
Fig. 7
Fig. 8
9
Fig. 9
